Monday, February 6, 2012

Tips and Strategy to Fix a Broken Laptop | power on the screen does not appear

If you have experienced damage to the laptop or even panic when the laptop is not working properly, so hurry take it to service center, but a corrupt software could be a good one caused.Ada we first analyze the problem starts from the most minor problems . If the laptop can still get into the bios loading setup.The big problem may be just the software alone

Often the damage to the notebook / laptop protect error occurs because the hardware (system protection) that was designed by the hardware manufacture to protect against damage hardware (example: Intel chip set on TEMPERATURE above 60 degrees Celsius, will decide the flow of himself to avoid over-heating).

Before concluding hardware damage to the notebook / laptop would be nice to do a standard analysis of the damage.

Some of the symptoms that arise when the notebook protects itself from over-heating:

SYMPTOMS 1.Lead power on the screen does not appear

A. Refrigerate for a moment to out of notebook battery, turn on using the ac adapter
2. Open the cover (bottom portion laptop) memory memory slot.Get off then move to another slot (if there are two memory slots) ... for some kind of laptop that only has one memory slot, remove the memory and reinstall it.
3. Open the hard drive cover, remove the hard disk and try to turn it back on.
4. Several notebook processors .. Can be seen just by opening the bottom cover portion, may also try to step 5 on the processor
5. Plug it in again and try to turn it back on.

If the five phases mentioned above have been done but the notebook still not back to normal, then we can conclude there is a hardware problem with your notebook.

Damage to the lightest of the above symptoms is damage to the memory / simply replace with a new memory.

There are several possible damage caused by the symptoms mentioned above:

A. Processor or power supporters (APPN)
2. VGA chip (APPN)
3. Motherboard chip (APPN)
4. Bios chip (ic epromer)

SYMPTOMS 2.No lead (indicator lamp) does not turn at all.
These symptoms arise due to the absence of a voltage (electric current) entering or voltage interruption caused by damage to the component power ..........

before concluding damage to the power component you should analyze the light that you can do yourself.

* Replace Adapter / Cable with similar power to ensure that the damage occurred to the adapter / cable, or on your laptop.
* Remove the Battery. To ensure no interruption caused by damage to your laptop battery.
* Note the lead (indicator lamp) on the adapter is lit or blinking normally (drop). If this happens, certainly the problem occurs on laptop power ic. It's better, the component directly contact the nearest service center ..
* Hopefully this article can help a friend


Post a Comment